Skip to content

Bluetooth mode

One firmware, two ways to reach the iPhone. The board is the iPhone’s mouse and keyboard either over a USB cable or over Bluetooth. You pick one on the installer and can switch later in the app. Bluetooth mode needs board firmware v0.2.7 and Manina AI 1.0.8 or newer, on TestFlight for now.

  • Lightning iPhones (XS – 14). No camera adapter needed: nothing plugs into the phone.
  • Any iPhone you’d rather keep free, for charging, a case, or a stand.

Over USB the phone powers the board. In Bluetooth mode the board needs its own power: any USB charger or power bank on its USB-C port. Keep it near the phone, with the antenna attached.

  • When installing. On manina.ai/install, pick your iPhone. Lightning models select Bluetooth; USB-C models can pick it in Connect by. The page installs over the cable, then switches the board to Bluetooth. Details: Using the app.
  • Later, in the app. Settings › Board › Input: USB or Bluetooth. The board restarts and reconnects in a few seconds; start Screen Mirroring again afterwards.
  1. Power the board and keep it near the iPhone.
  2. In Manina AI, pick the board and tap Pair when iOS asks. This is the app’s own connection.
  3. Turn on Settings › Accessibility › Touch › AssistiveTouch. Under Devices › Bluetooth Devices, tap the board. This makes it the iPhone’s mouse and keyboard. AssistiveTouch is still needed, as over USB.
  4. Start Screen Mirroring: swipe down from the top-right corner and tap Screen Mirroring › ESP32 Agent.
  5. Calibrate when the app asks (Settings › Calibration).

After switching in the app, the app shows these steps and ticks each one off.

  • Home is the swipe up from the home bar: iOS ignores a Home key from a Bluetooth keyboard.
  • The picture still comes over the board’s Wi-Fi (Screen Mirroring), as over USB. Bluetooth carries only the mouse, keyboard and the app’s commands.
  • After a long session the picture can get stuck. The app shows a tip; stop and start Screen Mirroring again.
  • The install page says “not on Bluetooth yet”. The board is installed but still in USB mode. Unplug it, plug it back into the same computer, wait five seconds, and click Switch to Bluetooth; pick the board if the list opens. You can also switch later in the app: Settings › Board › Input.
  • The pointer doesn’t move, or the app waits for the Bluetooth pointer. Check that AssistiveTouch is on and the board is paired under Devices › Bluetooth Devices, has power, and is near the phone.
  • Pairing fails, or the board was paired with older firmware. In Settings › Bluetooth, tap (i) next to the board, choose Forget This Device, then pair again as above. A fresh install from the website erases the board’s pairings, so pair again after it too.
  • Taps land in the wrong place after switching. Calibrate again in Settings › Calibration.
  • Updating the firmware. A board installed with the USB / Bluetooth choice is updated by installing it again from the website: Firmware updates.

More: Hardware & buying and Lightning iPhone.