On your phone
Start with the app.
Installing the board firmware needs Chrome or Edge on a computer, once. Everything else happens on your iPhone.
Needs iOS 18 or later: iPhone XS / XR and newer. iPhone X and older can’t run the app.
Manina AI works with an iPhone. The board itself is set up from a computer, in Chrome or Edge.
A one-time setup
Give your board
a pair of hands.
In App Store review. Use TestFlight for now.Imagine launch day. Big story.Needs iOS 18+ (iPhone XS / XR or newer).
Join TestFlightPublic beta. Get the app first.Needs iOS 18+ (iPhone XS / XR or newer).
Join TestFlightBoard firmware
XIAO ESP32S3
Chrome or Edge on a computer · USB data cable
- Power the board from any USB charger or power bank, near your iPhone.
- Open Manina AI (1.0.8 or newer), pick the board and confirm the iOS pairing request.
- Turn on Settings › Accessibility › Touch › AssistiveTouch. Under Devices › Bluetooth Devices, tap the board.
Need help?
Not using a XIAO ESP32S3?+
Other ESP32-S3 boards usually work too.
- Needs
- Native USB (USB-C straight to the chip)
- 8 MB flash or more
- 8 MB PSRAM or more
- Won’t work
- ESP32-C3, C6, S2 or the original ESP32
- Boards with a CH340 / CP2102 USB-serial chip
Your AI can help, too.
Then, over to your iPhone
Unplug. Plug in. Open Manina AI.
Power it. Pair it. Open Manina AI.
The app will walk you through connecting the board and getting started.
Any USB charger powers the board. The app pairs it over Bluetooth and walks you through the rest.
Get the app on TestFlight ↗Setup guide →How this AI uses an iPhoneLike it? Star it on GitHub ↗
Watch it once
Connect, pick the board, wait half a minute.
My board doesn't show up.
Use a USB cable that carries data, not a charging-only cable. Connect directly to the computer and close any apps using the board.
Still missing? Hold BOOT while plugging in the board, then release it and try connecting again.
It says “Failed to connect with the device”.
A board running Manina AI firmware may not offer a serial port the installer can use. Unplug it, hold BOOT while plugging it back in, release, then click Connect board and pick the new port.
Step-by-step fix ↗Which board should I use?
This installer is for the Seeed Studio XIAO ESP32S3, the standard version with 8 MB flash and 8 MB PSRAM. Other ESP32-S3 boards with native USB, at least 8 MB flash and 8 MB PSRAM should work but aren't tested. Other chips, such as the ESP32-C3, aren't supported.
See the board ↗Can I do this on my iPhone?
Use Chrome or Edge on a computer for this installation. Once it's finished, the board works with your iPhone. You won't need the computer to run Manina AI.
What happens to the firmware already on my board?
Installation replaces the board's current firmware. Back up anything you need before installing. It doesn't change anything on your computer or iPhone.